Ospfv2 with router on a stick update#
Ospfv2 with router on a stick mac#

They only send out updates when a new network is added.They use hop count as their only metric.What best describes the operation of distance vector routing protocols?.The router will load balance and forward packets to both R1 and R3.*.The router will forward the packet to R3.The router will forward the packet to R1.What would the router R2 do with a packet that is originating from the 192.168.4.0/24 network and destined for network 172.16.1.0/24? A network administrator is utilizing RIPv1 in the exhibited network topology. Which two routing protocols fulfill this requirement? (Choose two.) A new chief information officer (CIO) has requested implementation of a link-state dynamic routing protocol.When a range of ports is being configured for EtherChannel, which mode will configure LACP on a port only if the port receives LACP packets from another device?.When EtherChannel is implemented, multiple physical interfaces are bundled into which type of logical connection?.Spanning Tree Protocol ensures redundancy by transitioning failed interfaces in an EtherChannel to a forwarding state.Spanning Tree Protocol views the physical links in an EtherChannel as one logical connection.*.EtherChannel uses upgraded physical links to provide increased bandwidth.Load balancing occurs between links configured as different EtherChannels.

Configuring the EtherChannel interface provides consistency in the configuration of the physical links.*.

What are two advantages of EtherChannel? (Choose two.).

Which switching technology would allow data to be transmitted over each access layer switch link and prevent the port from being blocked by spanning tree due to the redundant link?

Ospfv2 with router on a stick mac#

The STP instance on Switch_2 is using the default STP priority and the election is based on Switch_2 MAC address.

The STP instance on Switch_2 is failing due to no ports being blocked and all switches believing they are the root.

The bridge priority of Switch_2 has been lowered to a predefined value to become the backup root bridge.

The bridge priority of Switch_2 has been lowered to a predefined value to become the root bridge.*.

Which statement is correct based on the command output? A network administrator is verifying the bridge ID and the status of this switch in the STP election.

Which industry-wide specification was developed to decrease the time that is needed to move to the forwarding state by switch ports that are operating in a redundantly switched topology?.

Which spanning tree standard was developed by Cisco to provide separate instances of 802.1w per VLAN?.

Which part of the inter-VLAN configuration causes the problem? However, host PCA cannot communicate with PCB. The configuration shows the commands entered by a network administrator for inter-VLAN routing.

Which three pairs of trunking modes will establish a functional trunk link between two Cisco switches? (Choose three.).

Configure interfaces on the switch that has connected hosts in the new VLAN and reboot the switch.

Manually add the VLAN to the VLAN database of the VTP servers.*.

Configure a port on the VTP servers for the same VLAN as the new VLAN.

Change the switch that has connected hosts in the new VLAN to be in VTP server mode.

What is the best method to add this VLAN to the network? The company uses VTP and the VLAN is not directly attached to either of the switches configured as VTP servers.

A network administrator is adding a new VLAN for testing.

Ospfv2 with router on a stick update#

All switches in the network will update their VTP database to reflect the VTP database of the new switch.

The VTP databases will remain unchanged in all switches with the exception of the newly added switch.*.

The newly added switch will automatically switch to VTP client mode.

The network will no longer share VLAN database updates.

The new switch has a VTP revision number of 4.

A new switch that has been configured as a VTP server is added to the network. All switches currently have a VTP revision number of 5. A switched network has converged completely.Which command provides common information relevant to both types of devices? A network engineer is interested in obtaining specific information relevant to the operation of both distribution and access layer Cisco devices.In the Cisco hierarchical design model, which layer is more likely to have a fixed configuration switch than the other layers?.Which routing protocol is able to scale for large networks and utilizes non-backbone areas for expansion?.Thank you! We truly value your contribution to the website. We will update answers for you in the shortest time.

NOTE: If you have the new question on this test, please comment Question and Multiple-Choice list in form below this article.